
Soot, smoke, and charred framing handled by a licensed crew
Attic fire restoration BONITA CA done right the first time
When a fire starts in the attic, the damage hides above your ceiling until smoke stains the drywall below. Our attic fire restoration BONITA CA crew finds the char, pulls the wet insulation, and rebuilds the framing before mold sets in. We handle attic fire damage repair in BONITA for homeowners in San Diego County, and we answer the phone 24/7. Call (833) 929-6186.
What's included
What our attic fire restoration includes
Every attic fire job is scoped to the damage, but the core work is the same. Here is what is covered from the first emergency call to the final walkthrough. If something extra comes up, like a cracked flue or a burned-out HVAC chase, we tell you before we do it and put it in the scope.
Emergency board-up and tarp
We tarp burned roof sections and board broken windows or vents within the first visit, usually 60 to 90 minutes after your call. That keeps rain and animals out of the attic while the scope is written.
Full tear-out of char and wet materials
Charred drywall, saturated insulation, melted wiring, and burned plywood come out and get bagged on site. We pull everything that cannot be saved so the rebuild starts from clean, dry framing.
Soot and smoke residue removal
We HEPA-vacuum every rafter bay, wipe soot-stained lumber with smoke sealant primer, and clean or replace HVAC ducts so smoke residue does not re-contaminate the house when the heat runs.
Structural drying and mold prevention
Dri-Eaz and Phoenix air movers plus a negative air machine dry the decking and framing. We log moisture meter readings daily until the wood hits 12 to 15 percent, which is dry for San Diego County.
Odor neutralization
Hydroxyl generators, thermal fogging solution, and charcoal odor absorbers run until a sniff test passes in every room. We do not mask the smell; we neutralize it at the source in the framing and insulation.
Framing, insulation, and roof rebuild
We sister or replace charred rafters, install new insulation, rebuild the roof deck, and replace shingles to California CSLB C-39 standards. Electrical runs are replaced to code and the inspection is scheduled before we close out.
Service overview
What attic fire restoration BONITA CA really involves
Attic fire restoration BONITA CA is the licensed trade of removing fire, soot, and suppression water from a roof cavity and returning the framing, insulation, and electrical runs to code. It starts with a thermal imaging camera scan to find hot spots the fire department missed, then a full tear-out of charred lumber, melted wiring, and saturated insulation. We set air scrubbers and HEPA vacuums to pull smoke residue out of the air before we rebuild.
Most attic fires in BONITA start at a junction box, a recessed light, or a chimney chase, and the fire department usually puts them out with 200 to 400 gallons of water. That water soaks the plywood decking and insulation, so attic fire damage repair in BONITA CA has to handle moisture as much as flame. If you are searching for attic fire damage repair near me BONITA after a scare, we can be on site the same day to scope it.
The service timeline
Our 5-step attic fire restoration process
The process flexes to the condition, but these checkpoints keep decisions clear.
Emergency board-up
We arrive within 60 to 90 minutes of your call, tarp the roof if shingles are burned through, and board any broken windows or vents. This stops rain and animals from getting into the attic while we plan the rebuild. You get a written scope the same day.
Thermal scan and tear-out
Our IICRC FSRT technicians run a thermal imaging camera across the ceiling and rafters to find hidden hot spots, then pull charred drywall, saturated insulation, and melted wiring. We bag debris in the driveway so soot does not track through your house. Tear-out usually takes 1 to 2 days.
Soot and smoke removal
We HEPA-vacuum every rafter bay, wipe soot-stained lumber with smoke sealant primer, and run air scrubbers with HEPA filters to pull fine particles out of the air. Ductwork gets cleaned or replaced, because smoke residue in HVAC ducts will re-contaminate the house the first time the heat kicks on.
Drying and odor control
We set Dri-Eaz and Phoenix air movers plus a negative air machine to dry the decking, then run hydroxyl generators and thermal fogging to neutralize odor at the molecular level. Moisture meter readings are logged daily until the framing hits 12 to 15 percent, which is dry for this climate.
Rebuild and final walk
We replace insulation, install new drywall, and rebuild the roof deck and shingles to California CSLB C-39 standards. Electrical runs are replaced to code, and we schedule the inspection. Before we leave, we walk the attic with you and hand over the moisture log and warranty paperwork.
Tools & methods
Tools and methods we use on attic fire jobs
Purpose-built equipment, used by trained technicians, so the job is done accurately the first time.
Thermal imaging camera
Finds hot spots and hidden char behind drywall and insulation that the eye cannot see, so we do not close up a wall with an ember still smoldering inside.
Air scrubber with HEPA filters
Pulls fine soot and smoke particles out of the air during tear-out and drying, keeping the rest of the house clean while the attic is open.
Hydroxyl generator
Neutralizes smoke odor at the molecular level without ozone, safe to run in occupied homes during the odor-control phase.
Negative air machine
Creates negative pressure in the attic so soot and mold spores do not migrate into the living space during demolition and drying.
Dri-Eaz and Phoenix air movers
Dry the roof decking and framing after firefighting water soaks the cavity, logged daily with a moisture meter until the wood hits 12 to 15 percent.
HEPA vacuum and pry bar
HEPA vacuum removes soot from every rafter bay, and the pry bar lets us probe charred lumber to see how deep the damage goes before we decide to sister or replace.
Use cases
When BONITA homeowners call us for attic fire restoration
These examples show how the service framework adapts rather than forcing every call through one repair.

Chimney fire rebuild in Bonita Bay
A chimney fire cracked the flue and burned into the roof deck, charring four rafters and burning through the shingles. Rain was forecast for the next day, and the roof was open to the sky. → We tarped the roof within 90 minutes, replaced four rafters and the burned decking, and rebuilt the shingles to C-39 standards. The framing dried to 14 percent, and the odor cleared in five days. The city signed off in 21 days.
Smoke-only attic fire in San Carlos Estates
A small attic fire was put out fast, but smoke traveled through the vents and settled in every rafter bay of a four-unit rental building. Tenants in three units complained about the smell, and the property manager needed each unit documented separately. → We HEPA-vacuumed every bay, sealed the framing with smoke sealant primer, cleaned the shared ductwork, and ran thermal fogging and charcoal odor absorbers until each unit passed a sniff test. Each unit got its own photo file and moisture log. The job finished in 12 days.
Problems we solve
Attic fire problems we solve in BONITA
Attic fires leave damage you can see and damage you cannot. These are the problems we run into most often in BONITA homes, and what happens if they are left alone.
Smoke odor that lingers months after the fire
We remove the source, seal the framing with smoke sealant primer, and run hydroxyl generators and thermal fogging until a sniff test passes. Most BONITA homes clear the odor in 3 to 5 days, not months.
Charred rafters that look fine but are not
We probe every rafter with a moisture meter and pry bar, sister or replace anything compromised, and rebuild to California CSLB B-1 and C-39 standards. The attic passes inspection the first time.
Mold growth from firefighting water
We extract standing water, set Dri-Eaz and Phoenix air movers with a negative air machine, and treat the cavity with Fiberlock encapsulant. Moisture readings are logged daily until the framing is dry.
Smoke residue in HVAC ducts
We clean or replace the ductwork as part of the job and run air scrubbers with HEPA filters until particle counts drop. That stops the re-contamination cycle before you move back in.
Pricing process
What attic fire restoration costs in BONITA
$4,500 - $18,000 depending on scope
Square footage of the burn
A fire contained to one rafter bay costs far less than one that spread across the whole roof deck. Tear-out, drying, and rebuild are all priced by the square foot of affected area.
Framing and roof deck damage
Sistering a charred rafter is cheaper than replacing it, and replacing a section of decking is cheaper than a full roof rebuild. Engineered trusses in newer BONITA homes cost more to repair because they follow the manufacturer's spec.
Insulation and ductwork replacement
Saturated insulation has to be replaced, and smoke residue in HVAC ducts means cleaning or replacement. Both are line items that add to the total but are necessary to stop odor from coming back.
How much does attic fire restoration cost in BONITA CA?
Most attic fire restoration jobs in BONITA run $4,500 to $18,000 in 2026, depending on how much framing and insulation has to be replaced. A small fire contained to one rafter bay with light smoke damage lands near the low end. A fire that burned through the roof deck and soaked insulation with suppression water lands at the top. We give you a written scope before any work starts, and we bill insurance directly when you file a claim.
Who does attic fire damage repair near me in BONITA?
Fire Damage Restoration Bonita does attic fire damage repair in BONITA California, and we are licensed through the California Contractors State License Board for both general building and roofing. We handle tear-out, drying, odor control, framing, insulation, and shingle replacement in one job. Call (833) 929-6186 and we will schedule a same-day inspection, usually within 60 to 90 minutes for emergencies.
Can attic fire damage be restored in BONITA California?
Yes, most attic fire damage can be restored rather than rebuilt from scratch. Charred rafters get sistered or replaced, smoke-stained lumber gets sealed with primer, and saturated insulation gets swapped out. The key is catching it fast, because firefighting water in a warm San Diego County attic can grow mold in 24 to 48 hours. We dry the cavity with air movers and a negative air machine before any rebuild starts.
How long does attic fire restoration take in BONITA CA?
A typical attic fire restoration in BONITA takes 2 to 4 weeks from emergency board-up to final walkthrough. Tear-out and drying run 3 to 7 days, odor control adds 2 to 5 days, and the rebuild depends on permit timing with the city. Small fires contained to one area can finish in 10 to 14 days. We give you a day-by-day schedule after the first inspection so you know when you can move back in.
Ready when you are
Need attic fire restoration BONITA CA today?
We answer the phone 24/7 and roll a crew to BONITA addresses within 60 to 90 minutes. One call gets you board-up, tear-out, drying, odor control, and rebuild under one licensed contractor. Call (833) 929-6186 and we will schedule your same-day inspection.

Talk with the local team
Request Attic Fire Restoration
Our phone is answered 24 hours a day, including holidays, and a crew can be dispatched across BONITA and San Diego County the same night. Call (833) 929-6186 and tell us what burned, what is wet, and whether the structure is secure. We will tell you what happens next before we hang up.


